Foxwell NT530 Pro for Mercedes-Benz Diagnostic Scanner Tool Multiplexer 38 PIN Cable

Oil/Service/Brake Service Reset Function

The NT530 allows you to reset Oil,Service, and Brake Lights in a click of a button on supported vehicles. On vehicles where a manual reset is required, the tool will guide you through the full process step-by-step.

EPB Reset Function

Brake Pad / Shoe changes on vehicles equipped with EPB's (Electronic Parking Brakes) MUST be carried out using a Diagnostic Tool to correctly re-calibrate. The NT530 offers you that capability on supported models. De-activate to Service Position - Replace - Re-activate.

SAS Reset Function

The Steering Angle Sensor (SAS) is used to measure the angle of the steering wheel and the speed at which it is being turned. The signal is mainly used by the ABS System as part of it's stability control function but also by other systems such as ride level control and adaptive lighting. A problem with the SAS Signal will cause a fault with any of the systems that use the signal directly, or indirectly.

If the Steering Angle Sensor (SAS) needs to be changed, many vehicle's require the new sensor to be calibrated. The NT530 will allow you to carry out steering angle re-calibration on supported models.

DPF Regeneration or Replacement

Carry out a forced Diesel Particulate Filter (DPF) Regeneration on supported vehicles - this MUST be done by trained personnel. Required when the DPF filter blockage reaches levels where passive or active regeneration is unable to burn off the excess soot. The NT530 is also capable of adapting a new DPF Filter where supported.