3-piece Rear Bumper Molding Cover Trim for 1984-1991 BMW E30 316i 318i 320i 325i
Product Description
Refresh the rear of your BMW E30 with this three-piece European-style bumper molding set. Designed for late-model plastic bumpers, the kit replaces damaged, faded, or missing trim and eliminates the U.S.-spec side-marker openings for a cleaner Euro appearance.
Product Details
- New aftermarket rear-bumper molding set
- Three-piece design: center, left, and right sections
- Black molded-plastic construction
- European-style trim without side-marker openings
- Clip-in replacement design
- No drilling normally required
- Manufacturer number: BACP000532
- Two-year seller warranty
- Installation hardware included
Reference Part Numbers
- 51121945926 — center bumper guard
- 51121945927 — left trim strip
- 51121945928 — right trim strip
- 51129061228
- 51-12-9-061-228
The BMW numbers are provided solely as interchange references. This is an aftermarket replacement set and is not manufactured by BMW.
Compatibility
Fits BMW E30 vehicles equipped with the late-model plastic rear bumper, including select:
- BMW 316i
- BMW 318i
- BMW 318is
- BMW 320i
- BMW 325i
- BMW 325is
- BMW 325iX
The listing identifies a general 1984–1991 application range because E30 production dates varied by model and market. For North American vehicles, the late plastic bumper was generally used on later-production E30 models, while early cars were commonly equipped with projecting aluminum bumpers.
Critical Fitment Requirement
This set fits late-model plastic bumpers only. It will not directly fit:
- Early aluminum “diving-board” bumpers
- Early European chrome bumpers
- BMW E30 M3 bumpers
- Vehicles with a different or aftermarket bumper configuration
BMW parts references associate the center section with vehicles produced from approximately June 1988, making the installed bumper style more important than the model year alone. BMW bumper reference
Euro-Style Configuration
This kit does not have openings for the side-marker lights found in U.S.-spec rear-bumper trim. Installing it on a U.S.-market vehicle may require the side-marker wiring and bulbs to be safely disconnected, secured, or otherwise addressed in accordance with local lighting regulations.
Installation Notes
- Remove the existing rear-bumper trim carefully
- Inspect the bumper’s retaining slots and mounting points
- Test-fit all three sections before final installation
- The trim sections primarily clip into the bumper
- Each corner section may also require a retaining screw
- Professional installation is recommended if the bumper has been repaired, modified, or converted
Package Includes
- One center rear-bumper molding
- One left rear-bumper molding
- One right rear-bumper molding
- Mounting hardware supplied with the listing
The complete bumper, side-marker lights, wiring, brackets, and other exterior components are not included.
